Differenze tra le versioni di "BetaShapeko"
Jump to navigation
Jump to search
m (http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/) |
|||
| (6 versioni intermedie di 2 utenti non mostrate) | |||
| Riga 1: | Riga 1: | ||
| − | TinyG | + | '''TinyG''' - the original board, from Synthetos: |
| + | http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/ | ||
---- | ---- | ||
| − | G2: porting | + | '''G2''': TinyG porting on an Arduino Due board |
| Riga 14: | Riga 15: | ||
| − | Firmware | + | precompiled Firmware for Arduino DUE: |
| + | |||
http://synthetos.github.io/g2/ | http://synthetos.github.io/g2/ | ||
| − | https://github.com/synthetos/g2/tree/edge ( | + | https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one) |
| + | [[Category: fresatura]] | ||
| + | Slic3r-plugin (to be installed in Slic3r) | ||
| − | |||
| + | http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools | ||
| + | http://www.thingiverse.com/search?q=shapeoko&sa= | ||
| − | + | [[Category:Project]] | |
Versione attuale delle 16:33, 14 feb 2016
TinyG - the original board, from Synthetos: http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/
G2: TinyG porting on an Arduino Due board
Getting Started with G2:
https://github.com/synthetos/g2/wiki/Getting-Started-with-G2#software-needed-to-use-g2
Flashing G2 with OSX
https://github.com/synthetos/g2/wiki/Flashing-G2-with-OSX
precompiled Firmware for Arduino DUE:
http://synthetos.github.io/g2/
https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one)
Slic3r-plugin (to be installed in Slic3r)
http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools