Differenze tra le versioni di "BetaShapeko"
Jump to navigation
Jump to search
| Riga 4: | Riga 4: | ||
| − | '''G2''': porting | + | '''G2''': TinyG porting on an Arduino Due board |
| Riga 15: | Riga 15: | ||
| − | Firmware | + | precompiled Firmware for Arduino DUE: |
http://synthetos.github.io/g2/ | http://synthetos.github.io/g2/ | ||
| − | https://github.com/synthetos/g2/tree/edge ( | + | https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one) |
Versione delle 13:18, 14 lug 2014
TinyG - the original board, from Synthetos: http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/
G2: TinyG porting on an Arduino Due board
Getting Started with G2:
https://github.com/synthetos/g2/wiki/Getting-Started-with-G2#software-needed-to-use-g2
Flashing G2 with OSX
https://github.com/synthetos/g2/wiki/Flashing-G2-with-OSX
precompiled Firmware for Arduino DUE:
http://synthetos.github.io/g2/
https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one)
Slic3r-plugin (incluso nel pacchetto - da installare in Slic3r)
http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools