Differenze tra le versioni di "BetaShapeko"

Da WeMake Wiki.
Jump to navigation Jump to search
m (http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/)
 
(6 versioni intermedie di 2 utenti non mostrate)
Riga 1: Riga 1:
TinyG: the original board, from Synthetos.
+
'''TinyG''' - the original board, from Synthetos:
 +
http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/
 
----
 
----
  
  
G2: porting di TinyG su Arduino Due
+
'''G2''': TinyG porting on an Arduino Due board
  
  
Riga 14: Riga 15:
  
  
Firmware precompilato per Arduino DUE:
+
precompiled Firmware for Arduino DUE:
 +
 
 
http://synthetos.github.io/g2/
 
http://synthetos.github.io/g2/
  
  
https://github.com/synthetos/g2/tree/edge (ancora sperimentale ma consigliato - non per produzione)
+
https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one)
  
 +
[[Category: fresatura]]
  
  
 +
Slic3r-plugin (to be installed in Slic3r)
  
Slic3r-plugin (incluso nel pacchetto - da installare in Slic3r)
 
  
  
  
 +
http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools
  
 +
http://www.thingiverse.com/search?q=shapeoko&sa=
  
  
http://www.thingiverse.com/search?q=shapeoko&sa=
+
[[Category:Project]]

Versione attuale delle 16:33, 14 feb 2016

TinyG - the original board, from Synthetos: http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/



G2: TinyG porting on an Arduino Due board


Getting Started with G2: https://github.com/synthetos/g2/wiki/Getting-Started-with-G2#software-needed-to-use-g2


Flashing G2 with OSX https://github.com/synthetos/g2/wiki/Flashing-G2-with-OSX


precompiled Firmware for Arduino DUE:

http://synthetos.github.io/g2/


https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one)


Slic3r-plugin (to be installed in Slic3r)



http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools

http://www.thingiverse.com/search?q=shapeoko&sa=