Differenze tra le versioni di "BetaShapeko"

Da WeMake Wiki.
Jump to navigation Jump to search
 
(Una versione intermedia di uno stesso utente non è mostrata)
Riga 22: Riga 22:
 
https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one)
 
https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one)
  
 
+
[[Category: fresatura]]
  
  
Riga 33: Riga 33:
  
 
http://www.thingiverse.com/search?q=shapeoko&sa=
 
http://www.thingiverse.com/search?q=shapeoko&sa=
 +
 +
 +
[[Category:Project]]

Versione attuale delle 16:33, 14 feb 2016

TinyG - the original board, from Synthetos: http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/



G2: TinyG porting on an Arduino Due board


Getting Started with G2: https://github.com/synthetos/g2/wiki/Getting-Started-with-G2#software-needed-to-use-g2


Flashing G2 with OSX https://github.com/synthetos/g2/wiki/Flashing-G2-with-OSX


precompiled Firmware for Arduino DUE:

http://synthetos.github.io/g2/


https://github.com/synthetos/g2/tree/edge (still experimental ma working - for adventurous one)


Slic3r-plugin (to be installed in Slic3r)



http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools

http://www.thingiverse.com/search?q=shapeoko&sa=