Differenze tra le versioni di "BetaShapeko"
Jump to navigation
Jump to search
| Riga 29: | Riga 29: | ||
| − | + | http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools | |
http://www.thingiverse.com/search?q=shapeoko&sa= | http://www.thingiverse.com/search?q=shapeoko&sa= | ||
Versione delle 17:43, 12 lug 2014
TinyG - the original board, from Synthetos: http://makezine.com/magazine/motion-control-for-the-masses-the-tinyg-story/
G2: porting di TinyG su Arduino Due
Getting Started with G2:
https://github.com/synthetos/g2/wiki/Getting-Started-with-G2#software-needed-to-use-g2
Flashing G2 with OSX
https://github.com/synthetos/g2/wiki/Flashing-G2-with-OSX
Firmware precompilato per Arduino DUE:
http://synthetos.github.io/g2/
https://github.com/synthetos/g2/tree/edge (ancora sperimentale ma consigliato - non per produzione)
Slic3r-plugin (incluso nel pacchetto - da installare in Slic3r)
http://wiki.imal.org/howto/cnc-milling-introduction-cutting-tools